3D Systems CUBEX Betriebsanweisung PDF herunterladen (Seite 22)

FINE-TUNING YOUR PRINT PAD

1. Re-install the Print Pad before ne tuning.

2. Use the Up and Down arrows to reduce the gap between the print jet and Print Pad to approximately 2 mm. This will

enable ner leveling. (Fig. 74)

3. Use the two remaining visible bolts to repeat the leveling process.

4. Click the ‘Function’ button to leave the ‘Level’ menu, and return to the main menu.

CAUTION: Observe each axis movement and ensure the print jet is not touching the Print Pad. Moving the

axis when the print jet is touching the Print Pad will damage both the print jet and the Print Pad. If the print jet

touches the Print Pad, immediately lower the Print Pad using the Down arrow.

5. Remember to lock the 3 Print Pad bolts into position by tightening the lock nut under each with the 8mm spanner. To

stop the bolt from spinning while you tighten the nut, hold it in position with the 3mm hex driver found on the top side of

the Print Pad.

Fig. 65

Fig. 68

Fig. 74 Fig. 76 Fig. 77Fig. 75

Fig. 72 Fig. 73

Fig. 69 Fig. 70 Fig. 71

Fig. 66 Fig. 67

1 2 ... 17 18 19 20 21 22 23 24 25 26

Keine Kommentare

3D Systems CUBEX Betriebsanweisung Seite 22