3D Systems CUBEX Betriebsanweisung PDF herunterladen (Seite 25)

SETTING THE CUBEX PRINT JET OFFSETS

CAUTION: Do not use the offset menu unless you have been

advised to do so by Cubify Support, as changes to this may

affect the quality of multi-material prints.

PRINTING THE CALIBRATION FILE Download the CubeX calibration le

from (enter address here)

Print the CubeX calibration le as you

would any other print le.

READING THE CALIBRATION FILE The lines on the calibration print are

offset by 0.1 mm. The amount of

misalignment can be calculated by

counting the amount Scale 2 or 3 is

offset from Scale 1.

Scale 1 is printed by Print Jet 1.

This is the reference print jet. All

offsets are relative to Print Jet 1.

Scale 2 is printed by Print Jet 2.

This error amount is the amount

Print Jet 2 needs its offsets to be adjusted.

Scale 3 is printed by Print Jet 3. This error amount is the amount Print Jet 3 needs its offsets to be

adjusted.

HOW TO ADJUST THE OFFSETS Touch the relative offset to activate it, a plus and a minus will appear at the side of the screen. Use this

plus and minus to adjust the offset.

PRINT JET 2 Y OFFSET Compare the lines on “Y scale 1” and “Y scale 2” to nd the ones that most accurately line up. Because

variation is small, it may be easiest to spot 3 that look like they all line up. If this is the case, use the

middle one as the correct one. Mark this line with a pen for easier identication.

On “Y scale 2” count from the center line (with the arrow) to the marked line. If you are counting down,

the scale the number is negative. If you are counting up, the scale the number is positive. Write down

the offset.

In the example shown in Figure 33, the Y offset for extruder 2 is -0.4mm.

PRINT JET 3 Y OFFSET Compare the lines on “Y scale 1” and “Y scale 3” to nd the ones that most accurately line up. Because

variation is small, it may be easiest to spot 3 that look like they all line up. If this is the case, use the

middle one as the correct one. Mark this line with a pen for easier identication. On “Y scale 3” count

from the center line (with the arrow) to the marked line. If you are counting down, the scale the number

is negative. If you are counting up, the scale the number is positive.Write down the offset.

In the example shown in Figure 33, the Y offset for extruder 3 is +0.6mm.

PRINT JET 2 X OFFSET Compare the lines on “X scale 1” and “X scale 2” to nd the ones that most accurately line up. Because

variation is small, it may be easiest to spot 3 that look like they all line up. If this is the case, use the

middle one as the correct one. Mark this line with a pen for easier identication.

On “X scale “2 count from the center line (with the arrow) to the marked line. If you are counting left, the

scale the number is negative. If you are counting right, the scale the number is positive. Write down the

offset.

In the example shown in Figure 33, the X offset for extruder 2 is +0.9mm.

Fig. 33

HOW TO CONTACT CUBIFY SUPPORT

If you have any problems with your CubeX that cannot be solved using this manual, please contact cubifysupport@cubify.

com for your support related issues.

1 2 ... 20 21 22 23 24 25 26

Kommentare zu diesen Handbüchern

Keine Kommentare

3D Systems CUBEX Betriebsanweisung Seite 25

Kommentare zu diesen Handbüchern